Mounting Orientation for Roll-Ball Tilt Switches
How you mount a roll-ball tilt switch decides how it reacts when the equipment moves, and that in turn feeds the device's control or safety logic.
How Mounting Affects Switch Behavior
Inside the housing, a conductive ball rolls and makes or breaks contact at set angles. GBeeLee can tailor the trigger angle and adapt the mounting to the equipment. The installed orientation is the reference: when the unit sits upright, the ball stays in a defined position, and the circuit is either closed or open, depending on the model. Tilt past the trigger angle, and the ball moves, the contact changes, and a signal is sent.
GBeeLee describes a heating-appliance case: the switch sat inside the unit, cut power when the appliance tipped over, and restored power when the unit was set upright again. The mounting direction has to match the action you want.
Switch Types and Orientation
GBeeLee distinguishes single-direction, double-direction, and multidirectional roll-ball switches. Each type has its own conductive and open states relative to the installed orientation. Keep the model and that reference orientation together through design and assembly. The trigger angle and mounting can be customized, but the switch will only behave as intended if it is physically oriented the right way in the device.
Checking the Orientation
Confirm the upright and tilted positions you care about, and check the switch in those positions. Ask GBeeLee for samples, install them in the real geometry, and watch the output under actual movement.
Tilt Switches and Inclinometers: Trigger Detection vs. Angle Measurement
Who Makes Custom Voice Recording & Light-Activated Gift Box Modules?