When using touch switches, what issues do we usually ignore

When using touch switches, what issues do we usually ignore? In this article, we will describe in detail the issues that should be paid attention to when using touch switches as follows:

Matters needing attention when using the touch switch 1. Regarding the setting of welding conditions, please proceed according to the actual mass production conditions.

Please pay attention to the use of touch switches, because water-soluble flux may cause corrosion of the switch during soldering. Please avoid using water-soluble flux.

Please pay attention to the use of touch switches. If you use a voltage exceeding the rated voltage, poor contact may occur. Please confirm separately when using it under the above conditions.

Please note that the circuit settings (software settings) should be set to a combination of components that do not malfunction according to the hits and shocks specified for each switch type. Please note that the circuit should be set according to the hits and shocks specified for each switch type ( Software group) is a combination of components.

Matters needing attention when using the touch switch 5. The carbon contact point has the characteristic of changing the contact resistance due to the pushing load. When using it in a voltage divider circuit, please use it after sufficient confirmation.

Matters needing attention when using touch switches. This product is designed and manufactured under the premise of DC resistance load. When using other loads (sensitive load (L), capacitive load (C)), please confirm separately.

Please pay attention to the use of touch switches. Do not clean. For the flat shaft type, press the center of the switch as much as possible. For hinged structures, pay special attention to the position of the shaft when it is pressed down.

Matters needing attention when using touch switches. If corrosive gas is generated from the materials around the whole machine using the switch, it may cause bad contact and other phenomena, so please fully confirm in advance.

Note 9 When using a touch switch to solder terminals, if a load is applied to the terminals, the electrical characteristics may become loose, deformed and degraded due to different conditions. Please pay attention when using it.

Please note that the touch switch should not be used continuously for a long time near the upper and lower temperature limits. Please note that it should be within the scope of various environmental tests in the product specifications specified in the conditions of use.